User's Manual

User’s Manual

Continuous – The connection will be kept always on. If the connection is interrupted,

the router will re-connect automatically.

Connect On-Demand – Only connect when you want to surf the Internet. “Idle Time

Out” is set to stop the connection when the network traffic is not sending or receiving

after an idle time.

Manual – After you have selected this option, you will see the “Connect” button and

“Disconnect” button, click “’Connect” and the router will connect to the ISP. If you want

to stop the connection, please click “Disconnect” button.

Idle Time Out:

If you have selected the connection type to “Connect-On-Demand”, please input the idle time

out.

After you finish with all settings, please click ‘Apply’ button and the following

message will be displayed on your web browser:

Please click ‘Continue’ to back to previous setup menu; to continue on other setup

procedures, or click ‘Apply’ to reboot the router so the settings will take effect (Please wait

for about 30 seconds while router is rebooting).

If you want to reset all settings in this page back to previously-saved value, please click

‘Cancel’ button.

 Setup procedure for ‘PPTP xDSL’:

PPTP xDSL requires two kinds of setting: WAN interface setting (setup IP address) and

PPTP setting (PPTP user name and password). Here we start from WAN interface setting: