User Manual

User’s Guide

♦ Channel

The current channel that be used for this WLAN adapter will be shown in this field.

♦ Encryption

All encryption status will be shown in this field.

♦ Link Speed

The current transmit rate will be shown in this field.

♦ Signal Strength

The signal strength bar graph is only active when the node is in infrastructure mode. The bar

graph displays normalized signal strength as reported by the radio, averaged over all frames

over 100 bytes long that are received from the AP.

♦ Link Quality

The Link Quality bar graph is only active when the node is in Infrastructure Mode. The bar

graph displays the quality of the link between the node and Access Point.

4.2 WPS Function

Wi-Fi Protected Setup (WPS) is a standard for easy and secure establishment of a wireless home

network, created by the Wi-Fi Alliance.

The goal of the WPS protocol is to simplify the process of connecting any home device to the

wireless network.

To secure your wireless network, you could push the “WPS” button under user interface as below:

There are two ways to enable WPS connection:

1. PBC mode: Choose a Router in the list then click “PBC” button.