User's Manual

WPEA-121N (WPEA-121N/W)
www.sparklan.com / [e-mail] / [phone]
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limit s are desig ned to provi de reas onable protectio n against harmf ul interfere nce in a residenti al
installation. This equipment gen erates, use s and can ra diate radio frequ ency energy and, if not inst alled and us ed in
accordance with the instructions, ma y ca use harmful int erference to radi o commun ications. Ho wever, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not e xpressly approved by the party responsible for c ompliance could void
the user's authority to operate this equipment.
This device co mplies with Pa rt 15 of the F CC Rul es/ Ind ustry Ca nada l icence-exempt RSS standar d(s). Operation is
subject to the following t wo c onditions: ( 1) This device m ay not c ause harmful interference, a nd ( 2) this d evice m ust
accept any interference received, including interference that may cause undesired operation.
This device is restricted to indoor use when operated in the 5.15 to 5.25 GHz frequency range.
FCC/IC Radiation Exposure Statement:
This equipment complies with FCC/ IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
FCC LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following " Contains TX FCC ID: RYK-WPEA-121N ". The
FCC part 15.19 statement below has to also be available on the label: This device complies with Part 15 of FCC rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device
must accept any interference received, including interference that may cause undesired operation.
IC LABEL OF THE END PRODUCT:
This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be
maintained between the antenna and users. The final end product must be labeled in a visible area with the following:
“Contains transmitter module IC: 6158A-WPEA121NW”.