User's Manual

(7)
End Product Labeling
This transmitter module is authorized only for use in device where the
antenna may be installed such that 20 cm may be maintained between the
antenna and users. The final end product must be labeled in a visible area
with the following: “Contains FCC ID: RYK-WNFQ258ACNBT”. The
grantee's FCC ID can be used only when all FCC compliance
requirements are met.
(8)
Manual Information To the End User:
The OEM integrator has to be aware not to provide information to the
end user regarding how to install or remove this RF module in the user’s
manual of the end product which integrates this module.
The end user manual shall include all required regulatory
information/warning as show in this manual
IC Compliance Statement:
(1)
This device complies with RSS-247 of the Industry Canada Rules. Operation is subject
to the following two conditions :
(1) This device may not cause interference, and (2) This device must accept any
interference, including interference that may cause undesired operation of the device.
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
(1)
Cet appareil radio est conforme au CNR-247 d’Industrie Canada.
L’utilisation de ce dispositif est autorisée seulement aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.