User's Manual

7
Wireless Module
Commission to operate with the antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater than the maximum gain
indicated for any type listed are strictly prohibited for use with this device.
Unique antenna connector (RP-SMA) must be used on the Part 15 authorized transmitters used in
the host product.
Antenna Type Antenna Model
Maximum Gain (dBi)
Remark
2.4 GHz 5GHz
Dipole AD-103AG 2.02 dBi 2.03 dBi
Dipole AD-302N 3.14 dBi 2.73 dBi
Dipole AD-303N 3.14 dBi 3.24 dBi
Length of Antenna cable:150mmConnector type of Antenna cable: I-PEX/MHF4 to RP-SMA(F)
If the FCC identification number is not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label referring
to the enclosed module. This exterior label can use wording such as the following: “Contains
Transmitter Module FCC ID: RYK-WNFB265AXIBT” Or “Contains FCC ID: RYK-WNFB265AXIBT”
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC transmitter
rules) listed on the grant, and the host product manufacturer is responsible for compliance to any
other FCC rules that apply to the host not covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular
transmitter installed.