User's Manual

Here are descriptions of every setup items:
Wireless mode Select wireless operation mode, available options
are 802.11 B/G mix, 802.11 B only, and 802.11
B/G/N mix. You can select 802.11 B/G/N mix to
maximize wireless compatibility with wireless
access points and other wireless devices. Anyway,
you can set this setting to ‘802.11 B only’ when
you’re going to communicate with old 802.11b
wireless devices and you got problem using other
two modes.
Wireless This setting helps your network card to avoid
Protection interference with other wireless devices when there
are both 802.11b and 802.11g wireless devices in
the same place. It’s recommended to set this setting
to ‘Auto’ , since enabling this setting will slightly
reduce the data transfer performance.
TX Rate Normally, the wireless network card will adjust
transfer rate automatically according to wireless
signal quality. However, you can fix the data
transfer rate to a lower fixed rate if you think there’s
some problem about data transfer, or you’re too far
from wireless access point. It’s recommended to set
this setting to ‘Auto’, unless you really know the
meaning of this setting.
Tx BURST Check this box to accelerate the data transmit rate.
It may not work with all wireless access point and
wireless devices.
Enable TCP Check this box and the configuration utility will
Window Size adjust TCP window size automatically, to get better
performance. It should be safe for most of wireless
environments, but if you found some problem on
data transfer, uncheck this box.
Fast Roaming at Check this box and you can adjust the threshold of