User's Manual

Standards
IEEE 802.3, IEEE 802.3u, IEEE 802.11a,
draft standard ,Wi-Fi compliant
Warranty 1 year
Temperature Range 0 ~ 50°C (Operating); -20 ~ 85°C (Storing)
Operating Humidity 10% to 85% Non-Condensing
Storage Humidity 5% to 90% Non-Condensing
Operating Range Open Space: Up to 260 m: Indoor: 100 m
The transmission speed varies in the surrounding environment
Network Protocol TCP/IP, IPX, NDIS4, and NDIS5 ,NDIS 5.1
Management Utility Monitor Internet Access Status via UI
EMC certification
TBD
(FCC part 15C/15.247; ETS 300 328-2; UL; IEC60950; EN
301 489-1,17; prEN50371; CE Mark; TELEC)
System Requirements Laptop PC containing
Æ MINIPCI local bus slot
Æ 64MB memory or greater
Æ 300MHz processor or greater
Microsoft Windows 98 Second Edition/Millennium Edition/2000/NT 4.0
with Service Pack 6,Windows XP
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not
expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Statement Needed to be Shown on End Product
Since this module is installed inside the end product, the end product should be
affixed a label on visible area showing that this product contain a RF module, and
also its FCC ID.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an