User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
8
4. First Time Configuration
TURN ON POWER SUPPLY
Quick power cycle would cause system corruption. When power on, be careful not to shut down in
about 5 seconds, because data is writing to the flash.
START UP & LOGIN
In order to configure the WCR-150GN, you must use web browser and manually input
http://192.168.1.250 into the Address box and press Enter. The Main Page will appear.
The configuration of this device is through web-browser. To access the configuration interfaces,
make sure you are using a computer connected to the same network as the device. The default IP
address of the device is 192.168.1.250, and the subnet-mask is 255.255.255.0. For the first time
configuration, please login with username: admin and password: admin.
Once you have logged-in as administrator, it is a good idea to change the administrator password to
ensure a secure protection to the WCR-150GN. The “Administrators Settings” can let you change the
password.
Once you have input the correct password and logged-in, the screen will change to the Setup page
screen.