User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
45
Make sure that mode, SSID, Channel and encryption settings are set the same on each wireless
adapter. Make sure that your computer is within range and free from any strong electrical devices
that may cause interference.
6. What devices cause interference?
Answer:
The AP is operating in the unlicensed 2.4 GHz band. Other devices operate in this frequency range
that may cause interference include microwave ovens and 2.4 GHz portable phones. PCs or analog
cellular phones do not operate at 2.4 GHz and do not cause interference. Proper placement of
access points usually eliminates interference problems created by other 2.4 GHz devices.