User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
42
8.4 Status
System Info
Item Description
Firmware Version
It shows the version of firmware on this device.
System Up Time
It indicates the time on this device. If the NTP client
is enabled, the time will sync with the NTP server.
Device Mode
It shows the operation mode of this device.
Internet Configurations
Item
Description
Connected Type
It shows the WAN type information such as DHCP,
Static IP, PPPoE, etc.
WAN IP Address
It shows the IP Address of the WAN interface.
Subnet Mask
This is subnet mask of the WAN interface.
Default Gateway
It is the default gateway of WAN interface.
Primary Domain
Name Server
It shows the primary DNS server.
Secondary
Domain Name
It shows the current secondary DNS server.