User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
41
8.3 Settings Management
In this page, you can export the setting, import the setting or load the factory default.
Item Description
Export Settings
To export the settings, click “Export” button to save
the configuration. In the pop up window, click “Open”
to open the configuration. You can read the
configuration in the next page. Click “Save” to save
the configuration file. The file extension is “.dat”.
Import Settings
To import the settings, click “Browse” to browse the
file, and then click “Import” to import the setting file.
Load Factory
Defaults
Click “Load Default” button to reset the device to
factory default. All users’ settings will be erased.