User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
36
WPS
The WPS AP lists in the top of the page. The bottom panel shows the status of WPS.
Please refer to the section 6.1, WPS section of Access Point mode for the operation.
WPS configuration
Item Description
Refresh
Click this button to refresh the WPS AP list.
Mode
This device supports Enrollee and Registrar in AP
Client mode.
PIN
This is the PIN code for PIN communication. Click
“Renew PIN” to generate a new PIN code.
PIN Start
Click this button to start PIN process.
PBC Start
Click this button to start PBC communication.
Cancel
Click this button to cancel the establishing WPS link.
Renew PIN
Click this button to discard current PIN and generate a
new PIN code.
Registrar Mode can let you change the AP, which you connect, information as below.