User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
35
Advanced
Advanced Configuration
Item Description
Wireless Mode
(Infrastructure)
Choose the proper Wireless Mode to connect remote
AP which provided by your WISP.
HT Physical Mode
Item Description
HT Physical Mode
(High throughput)
MM (Mixed Mode) or GF (Green Field).
Mixed mode: In this mode the device transmits the
packets with preamble compatible legacy (802.11g), so
they can be decoded by legacy devices. The device
receives and decodes both Mixed Mode packets and
legacy packets.
Green Field mode: the device transmits HT packets
without legacy compatible part. But the device receives
and decodes both Green Field and legacy packets.
Channel Bandwidth
Choose “20” for the standard bandwidth or “Auto” to
use the 40MHz bandwidth automatically.
MCS (Modulation
Coding Scheme)
Choose MCS. Please refer to the section of Access
Point.