User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
31
System Configuration
Item Description
Profile Name
Enter your profile name.
SSID
Enter the SSID of the AP or Ad Hoc network.
Network Type
Choose one between “802.11Ad Hoc” and
Infrastructure.
Power Saving Mode
For the Infrastructure network, this device can be setup
to CAM (Constantly Awake Mode) or Power Saving
Mode.
RTS Threshold
Check the box to setup the RTS Threshold. The default
value is 2347 and the available range is from 0 to 2432.
Fragment Threshold
Check the box to setup the Fragment Threshold. The
default value is 2346 and the available range is from
256 to 2432.
Security Policy
Item Description
Security Mode
Please choose the encryption method. The available
options are OPEN, SHARED, WPA-Personal and
WPA2-Personal.
Wire Equivalence Protection (WEP)
Item Description
WEP Key Length
Choose to use 64bit or 128bit length of key.
WEP Key Entry
Method
Select the key type. The available options are ASCII
Text or Hexadecimal.
WEP Keys
For WEP key, please input the key1-4. The key text and
the length must match the above settings.
Default Key
Select the default Tx WEP key.