User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
25
WEP Encryption Setting
Wired Equivalent Privacy (WEP) is implemented in this device to prevent unauthorized access to
your wireless network. The WEP setting must be as same as each client in your wireless network.
Authentication Type: Open, Shared and Auto. When choose “Open” or “Shared”, all of the
clients must select the same authentication to associate this AP. If select “WEP Auto”, the clients
don’t have to use the same “Open” or “Shared” authentication. They can choose any one to
authenticate.
Default Key ID: Select whether the Key ID as the default Key.
Key 1/2/3/4: Select “ASCII” or “Hex” and then type the key in the text field.
64-bit WEP Encryption：64-bit WEP keys are as same as the encryption method of 40-bit WEP.
When input 10 hexadecimal digits (0-9, a-f or A-F) or 5 ACSII chars as the key, it is using 64-bit
WEP encryption.
128-bit WEP Encryption：128-bit WEP keys are as same as the encryption method of 104-bit
WEP. When input 26 hexadecimal digits (0-9, a-f or A-F) or 13 ACSII chars, it is using 128-bit
WEP encryption.
WPA/WPA2-PSK:
Pass Phrase:
Option: Pass Phrase (8-64 characters). This mode requires only an access point and client station
that supports WPA-PSK. The WPA-PSK settings include Key Format, Length and Value. They
must be as same as each wireless client in your wireless network. When Key format is
Passphrase, the key value should have 8-64 ACSII characters.
Key Renewal Interval:
The WPA Algorithm will regroup the key for a period. The default value is 3600 seconds and you
can adjust the time interval.
Access Policy
For each SSID, the Access Policy can be selected and setup. The policy includes “Reject” and
“Allow”. The Reject policy rejects the station according to the MAC table in the policy configuration,
and let the other stations to connect. The allow policy performs reversely.
Add a station MAC: Key in station MAC Address in the text field. The valid format of the MAC
Address should be “xx:xx:xx:xx:xx:xx”. The station MAC Address can be found on the label or
configure utility of the WLAN card. For deleting one record in the table, click the “Del” button of the
record.