User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
24
Security
Wireless Security/Encryption Settings
Wireless Security/Encryption Settings
Item Description
Security Mode
OPEN, SHARED, WPA-PSK, WPA2-PSK
The available options are shown according to the numbers of the BSSID in the Basic Setting. Each
SSID can setup different encryption type. For example, set up 4 BSSID and 4 sets of security
shows on this page:
Security Mode: Choose one as the wireless authentication among the following types: OPEN,
SHARED, WPA-PSK,, WPA2-PSK
Encryption Type: Select one for the encryption type. The options vary depending on the
Authentication mode. The corresponding options shows below.
Authentication
Encryption
type
Key option
Open/Shared/WEP
Auto
WEP
Default Key ID, Key content of Key
1/2/3/4
WPA/WPA2-PSK
(Pre-Shared Key)
TKIP, AES,
TKIP/AES
(both)
Pass Phrase (8-64 characters),
Key Renewal Interval