User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
18
PPPoE: When the PPPoE (Point to Point Protocol over Ethernet) WAN Access Type is selected,
you must fill the fields of User Name, Password provided by your ISP. The IP configuration will be
done when the device successfully authenticates with your ISP.
Item
Description
User Name
The account is provided by your ISP.
Password/
Verify
Password
The password for your account. It is required to input again in
‘Verify Password’ in order to make sure the input password is
correct.
Operation
Mode
When selecting the “Keep Alive” mode, the redial time can be
set in this field. It will redial the connection to keep it online. The
default value is 60 seconds.
On demand: When selecting the “On Demand” mode, the idle
time can be set in this field. If the network is idle more than this
time, the WAN will disconnect.
MAC Clone
Clone device MAC address to the specify MAC address
required by your ISP