User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
16
5. Internet Settings
5.1 Configuring WAN Interface
The device supports three kinds of IP configuration for WAN interface, including Static IP, DHCP
Client and PPPoE. You can select one of the WAN Access Types that depend on your ISP required.
The default WAN Access Type is “Static IP”
STATIC: You can get the IP configuration data of Static-IP from your ISP. You will need to fill the
fields of IP address, subnet mask, gateway address, and one of the DNS addresses.
Item Description
IP Address
The Internet Protocol (IP) address of WAN interface provided
by your ISP or MIS. The address will be your network
identifier besides your local network.
Subnet Mask
The number used to identify the IP subnet network,
indicating whether the IP address can be recognized on the
LAN or if it must be reached through a gateway.
Default
Gateway
The IP address of Default Gateway provided by your ISP or
MIS.
Default Gateway is the intermediate network device that has