User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
15
4.2 Operation Mode
This device supports 3 modes for the IP network. Choose the Device Mode and click the “Apply”
button to change the modes.
Access Point: The device provides access between wireless stations and LANs. In this mode, the
Ethernet port becomes a “LAN” port.
Router: The device provides Router function. Choose this option, the Ethernet port will be acted as
WAN port. You can connect this port to the ADSL, cable modem or other devices for outbound
connection. At the same time, the WLAN interface will be LAN port in this operating mode.
AP Client: In this operating mode, the WLAN interface will be acted as “WAN” and “Wireless
Station (Client mode)” role. In this moment the NAT is enabled. This mode is usually used in WISP
(Wireless Internet Service Provider) application.