User Manual
Table Of Contents
- 2010-05-07_WCR-150GN user manual_rev05
- Copyright Statement
- 1. Introduction
- 2. Safety Notification
- 3. Hardware Installation
- 4. First Time Configuration
- 4.1 Install Wizard
- 4.2 Operation Mode
- 5. Internet Settings
- 5.1 Configuring WAN Interface
- 5.2 Configuring LAN Interface
- 5.3 DHCP Client List
- 6. Wireless Settings
- 6.1 Access Point & Router mode
- 6.2 AP Client mode
- 7. Firewall
- 7.1 DMZ
- 8. Administration
- 8.1 Management
- 8.2 Firmware Update
- 8.3 Settings Management
- 8.4 Status
- 8.5 Statistics
- 9. Troubleshooting – Q & A
- WCR-150-EC-DoC
- FCC + NCC Statement
User’s Guide
13
Basic Wireless Settings:
Radio State:
If you want to disable wireless function, please select ‘Turn OFF’.
Network mode:
Please select the radio band you want to use.
Network name (SSID):
This is the name of WCR-150GN. You can type any alphanumerical characters here, maximum 32
characters. SSID is used to identify your own wireless AP from others when there are other wireless
APs in the same area.
Hidden SSID:
This option can decide if the wireless AP will broadcast its own SSID or not. You can hide the SSID
of your WCR-150GN, so only people those who know the SSID of your WCR-150GN can get
connected.
Frequency (Channel):
You can keep the default channel setting ‘AutoSelect’ or select a channel from the dropdown list of
‘Channel’. Select one proper channel which does not employ in your environment can reduce radio
interference possibility.
After you finish with all settings, please click ‘Next’ button.