User's Manual

USER’S MANUAL OF Wireless 802.11g Multi-mode AP Version: 1.0
5
2 Installation
2.1 Hardware Installation
Step 1: Place the Wireless 802.11g Multi-mode AP to the best optimum transmission
location. The best transmission location for your Wireless 802.11g Multi-mode
AP is usually at the geographic center of your wireless network, with line of
sign to all of your mobile stations.
Step 2: Connect the Wireless 802.11g Multi-mode AP to your wired network. Connect
the Ethernet LAN interface of Wireless 802.11g Multi-mode AP by category 5
Ethernet cable to your switch/ hub/ xDSL modem or cable modem. A
straight-through Ethernet cable with appropriate cable length is needed.
Step 3: Supply DC power to the Wireless 802.11g Multi-mode AP. Use only the AC/DC
power adapter supplied with the Wireless 802.11g Multi-mode AP; it may occur
damage by using a different type of power adapter.
The hardware installation finished.
2.2 Software Installation
 There are no software drivers, patches or utilities installation needed, but only the
configuration setting. Please refer to chapter 3 for software configuration.
Notice: It will take about 55 seconds to complete the boot up sequence after
powered on the Wireless 802.11g Multi-mode AP; Power LED will be
active, and after that the WLAN Activity LED will be flashing to show
the WLAN interface is enabled and working now.