User Manual Part 2

63
QoS (Quality of Service)
Filter Priority and IP-ToS have not finished yet and also fine tuning.
QoS allows you to specify some rules, to ensure the quality of service in
your network. Such as use Bandwidth Priority concept to allocate bandwidth.
This function can be helpful in shaping and queuing traffic from LAN (WLAN)
to WAN or LAN to
WLAN, but not WLAN to WLAN.
Enable the QoS and then fill in Bandwidth Ratio (H/M/L) the device has
three Bandwidth Priorities High, Medium and Low user can allocation
Bandwidth to these and default is High:50и, Medium:30и and Low:20и.
The following table describes the priorities that you can apply to bandwidth.
Priority Level Description
High
Typically used for voice or video
applications that is especially sensitive to
the variations in delay.
Medium
Typically used for voice or video
applications that is especially sensitive to
the variations in delay.
Low
Typically used for non-critical traffic such
as a large number of transfers but that
should not affect other application.
Click the QoS link under Management to open the QoS Setting page. This
page is divided into three parts: basic settings, QoS rule settings, and current
QoS setting table.