User Manual Part 1

6
3.. After checking the ODU is mounted well, you can connect the following
two cables: the Waterproof RJ-45 network cable to “P+ DATA OUT” port of ODU
and the RF cable to antenna port. Additional waterproof tool, such as
waterproof tape, is recommended to use to enhance the waterproof function.
It is suggested to have a lightening protector between antenna and antenna
port. Connecting the ground wire as the figure of “ODU ground wire
connection.”
4. Plug the other end of the waterproof RJ-45 cable to the PoE device. The
PoE device is guaranteed only in indoor environment.
Caution: DON’T plug the power cord into PoE device before you finish install
the antenna and Ground wire to ensure the safety.
If the RJ-45 cable’s length is not long enough to connect to your
network
device for indoor parts installation, you can extend the cable length.
However, make sure the maximum length of the RJ-45 cable is shorter
than
100M (about 109 yards) for normal operation under IEEE 802.3ʳstandards.
When you plug the regular RJ-45 cable into the PoE device, you should use
the regular RJ-45 cable to plug into the “DATA IN” of “Power Over Ethernet
Kit” to connect to hub/switch or use the crosslink RJ-45 cable (Not included
in the Packing List) to connect with user’s PC
The waterproof RJ-45 cable must be connected to the “P+DATA OUT” port.