User Manual Part 1

Hardware Installation

Once you check off everything from the package, you can start to install the

ODU. You can mount to a pipe, a pole or to the side of a building. The steps are

showed in the followingΚ

1. You must mount the ODU into the bracket first.

Note: ALL the 4 screws had been tightened onto the ODU and Bracket

2. You can use the 2 or 4 inches U bolt to mount on the pipe, depending on

the radius of the pipe. (Wall mounting is referred to Wall Mounting Figure) The

two U bolts must be mounted tightly. Be aware of not over-tight the U bolt.