User Manual Part 1

Configure DEV2:

1. Access the web server (http://192.168.2.254). of device from the

Ethernet port.

Caution

If you configure multiple devices in the same PC, since the devices have

the same default IP address but different MAC addresses, it may cause you

not able to access the web server of device. If the situation happens, please

try to clean the ARP table of your PC by DOS command “arp –d” then you

can access the web server of device using the default IP address.

2. Use Wizard page to setup device.

3. Press “Next>>” button then set the “Operation Mode” to “Bridge”

mode.