Installation Guide

7
3.2 Mount Kit Installation
1. Assemble part
1 of the mount kit at the rear of OA200, shown in the above
figure.
2. If you are mounting the Access Point on a wall, first install the bracket
2 of
the mounting kit to a suitable position. Assemble the back of the OA200
housing to the bracket subsequently.
3. If you are mounting the OA200 to a pole, first install the bracket
2 and the clip
3 of the mounting kit to a strong pole. Assemble the rear of the OA200
housing to the bracket subsequently.
4. Insert the LAN cable to a Power over Ethernet socket. Make sure the power
LED and LAN link LED is light up.