Installation Guide

1. Please unscrew the screw part as above figure.

2. Please use the reset bar to reach the reset button. Press it and hold on for

approx 10 seconds.

3. Release the reset button, the device will reboot and all configurations will be

set to factory default settings automatically.

3.5

Antenna installation on OA200

antenna inside box, so the external antenna is necessary for this unit. Please

find the RP-SMA Antenna connector on the rear side of this box. Usually, it should be a

low loss RF cable connected between OA200N and antenna.

For decrease the signal loss, we strongly suggest using RF cable with high

quality and the length should be as short as possible. There are two RP-SMA types

connector at the rear side. One is Antenna 1, the other is Antenna 2

OA200 i s one 11ag AP seri es wi t h ext ernal ant enna. The cabl e wi t h mal e t o mal e 

N- t ype connect or wi l l be use t o connect wi t hOA- 200 physi cal ut i l i t y. The cabl e 

wi t h f emal e t o f emal e reverse N- t ype connect or shal l be used as ext ensi on cabl e 

t o est abl i sh connect i on wi t h RSMA convert er, The Ant enna wi l l be connect i ng t o 

RSMA convert er.