User's Manual

54
the same network should follow the same setting.
Select the channel designated by your wireless ISP.
Wireless Band (4): Check your Wireless ISP service provider either
2.4GHz or 5GHz wireless band is used for the
network and then select the wireless band here.
Site Survey (5): Click ‘Select Site Survey’ button, then a “Wireless
Site Survey Table” will pop up. It will list all
available access points nearby. Select the access
point designated by your wireless ISP in the table
and the router will join wireless network through
this access point.
Security Setting (6): If the access point enables wireless security, you
have to follow the same settings in order to access
the access point. Click to set security settings for
this connection (Please go to section ‘2-7-3
Wireless Security’ for detailed instructions).
After you finish with all settings, please click ‘Apply’ (7) button and the
following message will be displayed on your web browser:
Please click ‘Continue’ to back to previous setup menu; to continue on
other setup procedures, or click ‘Apply’ to reboot the router so the
settings will take effect (Please wait for about 30 seconds while router is
rebooting).
If you want to reset all settings in this page back to previously-saved
value, please click ‘Cancel’ button.