Data Sheet

NEO-M8P - Data Sheet
UBX-15016656 - R06 Early Production Information Default messages
Page 26 of 30
8 Default messages
Interface Settings
UART Output 9600 Baud, 8 bits, no parity bit, 1 stop bit
Configured to transmit both NMEA and UBX protocols, but only the following NMEA (and no UBX)
messages have been activated at start-up:
GGA, GLL, GSA, GSV, RMC, VTG, TXT
USB Output Configured to transmit both NMEA and UBX protocols, but only the following NMEA (and no UBX)
messages have been activated at start-up:
GGA, GLL, GSA, GSV, RMC, VTG, TXT
USB Power Mode: Bus Powered
UART Input 9600 Baud, 8 bits, no parity bit, 1 stop bit, Autobauding disabled
Automatically accepts following protocols without need of explicit configuration:
UBX, NMEA, RTCM
The GNSS receiver supports interleaved UBX and NMEA messages.
USB Input Automatically accepts following protocols without need of explicit configuration:
UBX, NMEA
The GPS receiver supports interleaved UBX and NMEA messages.
USB Power Mode: Bus Powered
DDC Fully compatible with the I
2
C industry standard, available for communication with an external host CPU or
u-blox cellular modules, operated in slave mode only. Default messages activated.
NMEA and UBX are enabled as input messages, only NMEA as output messages.
Maximum bit rate 400 kb/s.
SPI Allow communication to a host CPU, operated in slave mode only. Default messages activated. SPI is not
available in the default configuration.
TIMEPULSE disabled
Table 14: Default messages
Refer to the u-blox 8 / u-blox M8 Receiver Description Including Protocol Specification [2],for information
about further settings.