Data Sheet

<圖五>軸受固定示意圖。
10kgf.cm以下。
Tighten the nut according to <fig.5>
Tightening torque to be no
<圖五>
greater than 10kgf.cm.
<fig.5>
震顛雜音: t
1
,t
3
≦5ms
付摯子點機種需有摯子點的感
觸。
Detent feeling has to remains.
(Applied for detent type )
Except above items,
specicfications in clause 2.1~7
APPD. CHKD. DSGD.
VERSION :
PAGE :
DATE APPD DSGD
2010.10.11 2010.10.11 2010.10.11
DRAWING NO.:
3-9
安裝注意事項
Notice for
mounting
軸垂直側壓強度 不可有電氣或機械上的異常
Without damage or excessive play
3-8
Side thrust
軸前端5mm處，加上2Kgf的靜荷重10秒
A load of 2Kf shall be applied at the point 5mm
4–1
可 正 欣 有 限 公 司
TOP-UP INDUSTRY CORP.
廖智順 鐘學峰 余倩
EC12PLRGBSDVBF-D-25K-24-24C-61/08-6H
EC12PSD-017
B
7 OF 10
SYMB CHKD
DOCUMENT NO. :
Bounce: t2≦3ms
shall be made
and 3.1~8 shall be satisfied.
(1回轉為360°往返各一次)
cycles at a speed of 600~1000 cycles per hour
Phase-difference :△T≧2.5 msec
Chattering: t
1
,t
3
≦5ms
回 轉 壽 命
The shaft of encoder shall be rotated to 30,000
Rotational life without electrical load , after which measurement
(1 cycle： rotate 360°C.C.W. rotate 360° C.W.)
無任何電氣負荷下,軸以每小時600~1000回轉的速
相位差:∆T≧2.5msec
跳躍滑動雜音: t2≦3mS
度下,持續進行30,000回轉. 其它初期值亦需滿足
(After soldeting of the PC board)
四. 耐久性能 Endurance characteristics
NO
.
項 目條 件規 格
item conditions specifications
from the tip of the shaft in a direction perpendicular
shaft
to the axis of shatf.
in shaft .No excessive abnormalit
y
in rotational feeling.
strength of
3–7
軸回轉方向間隙
使用角度板測定 4度以內
Rotation play at
Measurement with jig for rotational angle . 4° MAX.
the click position
回 轉 式 位 元 產 生 器 規 格 書
ROTATIONAL ENCODER SPECIFICATION
NO.
項 目條 件規 格
item conditions specifications