Datasheet

3. Pin Definitions
Booting Mode
Pin Default SPI Boot Download Boot
IO0 Pull-up 1 0
IO46 Pull-down Don’t-care 0
Enabling/Disabling ROM Code Print During Booting
3 4
Pin Default Enabled Disabled
IO46 Pull-down See the fourth note See the fourth note
Note:
1. Firmware can configure register bits to change the settings of ”VDD_SPI Voltage”.
2. The strapping combination of GPIO46 = 1 and GPIO0 = 0 is invalid and will trigger unexpected behavior.
3. Internal pull-up resistor (R1) for IO45 is not populated in the module, as the flash in the module works at 3.3 V by
default (output by VDD_SPI). Please make sure IO45 will not be pulled high when the module is powered up by
external circuit.
4. ROM code can be printed over TXD0 (by default) or DAC_1 (IO17), depending on the eFuse bit.
5. When eFuse UART_PRINT_CONTROL value is:
0, print is normal during boot and not controlled by IO46.
1 and IO46 is 0, print is normal during boot; but if IO46 is 1, print is disabled.
2 and IO46 is 0, print is disabled; but if IO46 is 1, print is normal.
3, print is disabled and not controlled by IO46.
Espressif Systems 12
Submit Documentation Feedback
ESP32-S2-WROOM & ESP32-S2-WROOM-I Datasheet V1.1