Data Sheet

Page 51
RFM95/96/97/98(W)
Tel: + 86-755-82973805 Fax: + 86- 755-82973550 E-mail: [e-mail] http:/ / www.hoperf.com
WIRELESS & SENSING PRELIMINARY DATASHEET
4.2.5.1. Transmitter Startup Time
The transmitter startup time, TS_TR, is calculated as follows in FSK mode:
TS _ TR = 5 μ s + 1.25 × PaRamp +
1
× Tbit
2
,
where PaRamp is the ramp-up time programmed in RegPaRamp and Tbit is the bit time.
In OOK mode, this equation can be simplified to the following:
TS _ TR = 5 μ s +
1
× Tbit
2
4.2.5.2. Receiver Startup Time
The receiver startup time, TS_RE, only depends upon the receiver bandwidth effective at the time of startup. When AFC is
enabled (AfcAutoOn=1), AfcBw should be used instead of RxBw to extract the receiver startup time:
Table 68 Receiver Startup Time Summary
RxBw if AfcAutoOn=0
RxBwAfc if AfcAutoOn=1
TS_RE
(+/-5%)
2.6 kHz 2.33 ms
3.1 kHz 1.94 ms
3.9 kHz 1.56 ms
5.2 kHz 1.18 ms
6.3 kHz 984 us
7.8 kHz 791 us
10.4 kHz 601 us
12.5 kHz 504 us
15.6 kHz 407 us
20.8 kHz 313 us
25.0 kHz 264 us
31.3 kHz 215 us
41.7 kHz 169 us
50.0 kHz 144 us
62.5 kHz 119 us
83.3 kHz 97 us
100.0 kHz 84 us
125.0 kHz 71 us
166.7 kHz 85 us
200.0 kHz 74 us
250.0 kHz 63 us
TS_RE or later after setting the device in Receive mode, any incoming packet will be detected and demodulated by the
transceiver.