Guide

1/22/2018 micro:bot Kit Experiment Guide - learn.sparkfun.com
https://learn.sparkfun.com/tutorials/microbot-kit-experiment-guide/all#about-the-motobit-board 22/75
Route the Cables
Position the Top Chassis Plate over the Bottom Chassis Plate – but do not snap the two plates together yet. Make
sure that the front sides of each plate line up.
Route the wires and cables through the left and right oval slots in the Top Chassis Plate assembly as shown. For the
center line follower sensor, route this cable through the right oval slot. Note that SIK-only cables are listed with an
asterisk (*).
NOTE: It might be a good idea to use some pieces of masking tape to mark which cables go to which
component. It’s not necessary, but it might help keep things organized.
Cable Routing:
Cable Connection Oval Side
Left Line Follower Center
Center Line Follower Center
Right Line Follower Center
Left Motor wires (red and black) Left
Right Motor wires (red and black) Right