Guide

1/22/2018 micro:bot Kit Experiment Guide - learn.sparkfun.com
https://learn.sparkfun.com/tutorials/microbot-kit-experiment-guide/all#about-the-motobit-board 18/75
Attach the Cables
You will need to connect a 3-Wire Jumper Cable (K) to each of the Line Follower Boards (O). Note the color of the
wire attached to each pin.
Line Follower Connections:
Jumper Wire Color RedBot Sensor - Line Follower
Red GND
Orange VCC
Yellow OUT
Attach all 3 cables to the 3 Line Follower Boards. Notice that the yellow wire should be on the right (out) and the red
wire should be on the left (ground).