Manualshelf

Guide

ManualsBrandsSparkfun Electronics Manualsmicro:bit AccessoriesSparkFun moto:bit Board
11121314151617181920
1/22/2018 micro:bot Kit Experiment Guide - learn.sparkfun.com
https://learn.sparkfun.com/tutorials/microbot-kit-experiment-guide/all#about-the-motobit-board 17/75
Construct the Line Follower Assembly
Attach the three Line Follower Boards (O) to the Line Follower Mount (I) such that the rectangular pegs in the Line
Follower Mount poke through the mounting holes in the Line Follower Boards. Make sure the sensors are
facing away/down from the clip of the mount.
Place the Line Follower Mount Plate (J) on top of the Line Follower Mount (I) so that the center clip of the mount is
poking through the center slot of the plate.