Guide

1/12/2018 mbed Starter Kit Experiment Guide - learn.sparkfun.com
https://learn.sparkfun.com/tutorials/mbed-starter-kit-experiment-guide/all 9/65
Jumper Wire a6 h14
Jumper Wire a7 h22
Jumper Wire j20 j25
Jumper Wire j19 j27
Jumper Wire j18 j28
Jumper Wire a26 ( - )
Jumper Wire a8 ( - )
Jumper Wire a16 ( - )
Jumper Wire a24 ( - )
Tips
Pushbuttons
The leads across each other on the pushbuttons are always connected to each other. The leads on the same side are only connected when button is pressed.
LED
You can use a set of needle nose pliers to bend the LED’s leads and a pair of cutters to fit the LED in the breadboard. Note that there is a flat side on the plastic
ring around the bottom of the LED. This denotes the side with the pin that controls the red color. See this tutorial to learn more about polarity.
Resistors
330 ohm resistors are given by the color code “orange orange brown.”