Guide

Page 52
LIGHT-UP PLUSH
3
Stufng Your Plush
Once you’ve finished testing,
it’s time to make the plush three-
dimensional. Remove the battery
and fold the felt at the connected
points (feet) at the bottom so the
LilyPad components are on the
outside. Using non-conductive
sewing or embroidery thread (or a
glue gun) seal all but 2 inches at the
top of the plush; we will add fiberfill
stuffing in this opening.
Push the fiberfill stuffing into the hole to fill the plush. Use your fingers or a pencil to fill
up the arms and legs. The stuffing will give the plush its shape in addition to acting as an
insulator for the conductive thread stitching on the inside. Stitch the opening closed with
embroidery or sewing thread to finish the project.
CR2032
LITHIUM BATTERY
3V