Guide

Page 34
ILLUMINATED MASK
2
2
With a new piece of thread, repeat the process for the negative
side of the circuit – connecting the three LEDs’ negative sew
tabs to one another and, finally, the negative sew tab on the battery
holder. Tie a finishing knot and trim any excess thread.
Installing Your
Battery and Testing
Insert the coin cell battery into the battery holder with the
positive, labeled as (+), side facing up. Slide the switch to ON to
see the LEDs light up. Remove the battery, and then continue to
the Finishing Touches section.
CR2032
LITHIUM BATTERY
3V
3
2
1
Problems? See the Troubleshooting section
on page 70 to nd a solution.