Guide

Page 23
GLOWING PIN
1
GLOWING PIN
Arranging Your Circuit
Position the battery holder with the ON/OFF switch to the left side
and the bottom two sew tabs close to the bottom edge of the felt. Use
a small dot of hot glue in the center of the holder to attach it to the
felt, as shown. Gluing the battery holder on this way leaves room for
placing the LilyPad LED on the felt.
While planning the LED’s placement, note that it will need to be
slightly above the center or toward the top half of the fabric so it
doesn’t touch or overlap the battery holder.
ON
OFF
!
Remember: Glue is great for keeping your
components in place, but it can interfere with your
circuit. Try to keep glue clear of sew tabs.