Data Sheet

66 : circuit 3c
3. Attach the hook end of the
linkage rod to the end hole on your
servo mount. The motor should be
reattached to the baseplate with
Dual Lock.
4. Cut out the pop-up image of
your choice. We chose this public
domain menacing cat image
(http://sfe.io/cat). The image you
choose should be about 2.5 inches
x 2.5 inches and can be drawn or
printed. Leave a rectangular strip of paper under the image that is about 2 inches long.
5. Fold along the bottom of the image. Tape the bottom of the
pop-up to the underside of the breadboard baseplate on the
same side to which the servo is connected.
6. Tape the free end of the rod to the back
of your pop-up image, near the center.
7. Once you have the rest of the circuit built and the code
uploaded, you can fine-tune your moving pop-up and make
any necessary adjustments. Remember to wait until these
adjustments have been made before you screw the servo
mount onto the motor.