Data Sheet

66 : circuit 3c
. Attach the hook end of the
linkage rod to the end hole on your
servo mount. The motor should be
reattached to the baseplate with
Dual Lock.
. Cut out the pop-up image of
your choice. We chose this public
domain menacing cat image
(http://sfe.io/cat). The image you
choose should be about 2.5 inches
x 2.5 inches and can be drawn or
printed. Leave a rectangular strip of paper under the image that is about 2 inches long.
. Fold along the bottom of the image. Tape the bottom of the
pop-up to the underside of the breadboard baseplate on the
same side to which the servo is connected.
. Tape the free end of the rod to the back
of your pop-up image, near the center.
. Once you have the rest of the circuit built and the code
uploaded, you can fine-tune your moving pop-up and make
any necessary adjustments. Remember to wait until these
adjustments have been made before you screw the servo
mount onto the motor.
SIK v4 Book Oct 13.indb 66 10/18/17 10:01 AM