Product Overview

1/29/2018 ESP32 Thing Motion Shield Hookup Guide - learn.sparkfun.com
https://learn.sparkfun.com/tutorials/esp32-thing-motion-shield-hookup-guide?_ga=2.240586115.1022152466.1517244327-204410570.1509632255 5/17
Put the pin headers in the shield, and set the ESP32 Thing on top. Then, apply solder and build up nice fillets making
sure to not bridge any pins.
Adding an Optional Sensor
If you’re using a BME280 to try out the I2C or SPI port, install headers on it as well. See the BME280 Hookup
Guide for more information.
For generic operation solder both headers (left). If you only need I C (middle), or SPI (right), only attach those
headers.
3-Pin JST and microSD Card
Make sure the JST and microSD cards are installed properly.
If the JST connectors feel like they’re not going in, don’t force them, try wiggling them instead. They will hang
out a bit when properly seated.
The microSD card slot is dual position with click feature, and the PCB has a recess. The card should easily
click in and out.
2