Product Overview

1/29/2018 ESP32 Thing Motion Shield Hookup Guide - learn.sparkfun.com
https://learn.sparkfun.com/tutorials/esp32-thing-motion-shield-hookup-guide?_ga=2.240586115.1022152466.1517244327-204410570.1509632255 3/17
GPIO 21 I/O SDA IMU I2C SDA
GPIO 22 I SCL IMU I2C SCL
Hardware Assembly
In this section, we’ll prepare the shield for a development environment by adding headers. This section also shows
what the GPS module, battery, and SD card look like when properly inserted.
The completed stack.
Attach the Stackable Headers to the Motion Shield
Solder a single pin on each header. Make sure the headers are straight, and lined up. You can use perf board, or an
already populated ESP32 Thing to help with alignment.