Data Sheet

RFD77402 DATASHEET v1.8

www.simblee.com

Simblee™ RFD77402

2.1.2 I

C Write Access with Auto Increment and Word Mode Features

When performing a burst write to the I

C interface, the module response depends on the setting of bits 1:0 of the

C Init Configuration Register controlling the address auto increment features and word mode. If none of these

modes are enabled, the data burst write is going to be directed to the same I

C address. In case of address auto

increment, the data is written sequentially to the location starting with initial the I

C address. In case both modes

are enabled, each 2-byte from the data burst stream is going to overwrite the 2-byte location pointed by the I

address.

Figure 4: I

C Write Direct Access: Auto Increment and Word Mode Options

2.1.3 I

C Read Access with Address Auto Increment and Word Mode Features

The behavior of the address auto increment and word mode features are similar to the one previously described

for the I

C burst write.

Figure 5: I

C Burst Read: Address Auto Increment and Word Mode