Design Guide

Dev Kit Hardware
A DIVISION OF TRIMBLE
Appendix B: Getting Started - Dev Kit 113
Dev kit Jumpers
J8
Jumpers to connect ThingMagic Nano I/O lines to dev kit. For added safety, you should
remove all 3 jumpers for USB connections and the AUTO_BT connection to the module.
These lines are not supported, but are connected to the ThingMagic Nano module for test
purposes, so should be left unconnected for all applications.
J19
The jumper at J19 that connects SHUTDOWN to ground must be REMOVED. With this
jumper removed, the module is always operational. The AUTO_BOOT switch has no
affect on the ThingMagic Nano. To put the ThingMagic Nano into shutdown mode,
reinstall the jumper at J19 between SHUTDOWN and GND. See ThingMagic Nano Digital
Connector Signal Definition for details on the ENABLE Line.
J9
Header for alternate power supply. Make sure DC plug (J1) is not connected if using J9.
J10, J11
Jump pins OUT to GPIO# to connect ThingMagic Nano GPIO lines to output LEDs. Jump
pins IN to GPIO# to connect ThingMagic Nano GPIO to corresponding input switches.