Design Guide

Dev Kit Hardware
A DIVISION OF TRIMBLE
Appendix B: Getting Started - Dev Kit 111
“USB/RS232”. The one labeled “USB” is not supported by the ThingMagic Nano
module.
2. Plug the power supply into the Dev Kitʼs DC power input connector.
3. The LED next to the DC input jack, labeled DS1, should light up. If it doesnʼt light up
check jumper J17
to make sure the jumper is connecting pins 2 and 3
4. Follow the steps based on the Dev Kit USB Interface
used and make note of the COM
port or /dev device file, as appropriate for your operating system the USB interface is
assigned.
5. To start reading tags start the Demo Application
(Universal Reader Assistant).
WARNING!
While the module is powered up, do not touch components. Doing so
may be damage the dev kit and ThingMagic Nano module.