User Manual

ThingMagic Nano User Guide 58
www.JADAKtech.com
ThingMagic Nano does not support a USB port directly, so the “USB” port on the Development Kit is
inoperable.
A COM port should now be assigned to the ThingMagic Nano. If you aren’t sure what COM port is assigned
you can find it using the Windows Device Manager:
a. Open the Device Manager (located in Control Panel | System).
b. Select the Hardware tab and click Device Manager.
c. Select View | Devices by Type | Ports (COM & LPT) The device appears as USB Serial Port
(COM#).
Development Kit Jumpers
J8
Jumpers to connect ThingMagic Nano I/O lines to development kit. For added safety, you should remove all
3 jumpers for USB connections and the AUTO_BT connection to the module. These lines are not supported
but are connected to the ThingMagic Nano module for test purposes, so should be left unconnected for all
applications.
J9
Header for alternate power supply. Make sure DC plug (J1) is not connected if using J9.
J10, J11
Jump pins OUT to GPIO# to connect ThingMagic Nano GPIO lines to output LEDs. Jump pins IN to GPIO#
to connect ThingMagic Nano GPIO to corresponding input switches. Make sure GPIO lines are
correspondingly configured as input or outputs (see Configuring GPIO Settings).
J13, J15
Not used.
J14
Can be used to connect GPIO lines to external circuits. If used jumpers should be removed from J10, J11.