User Manual

ThingMagic Nano User Guide 55
www.JADAKtech.com
Tag ID Buffer Fault Errors
Message Code Cause Solution
FAULT_TAG_ID_BUFFER_NOT_ENOUGH_
TAGS_AVAILABLE
600h A command was received to get a
certain number of tag ids from the
tag id buffer. The reader contains
less tag ids stored in its tag id
buffer than the number the host is
sending.
Send a test case reproducing the
behavior to rfid-
[e-mail].
FAULT_TAG_ID_BUFFER_FULL 601h The tag id buffer is full. Make sure the baud rate is set to a
higher frequency that the /reader/
gen2/BLF frequency.
Send a test case reproducing the
behavior to
rfid-
[e-mail].
FAULT_TAG_ID_BUFFER_REPEATED_TAG
_ID
602h The module has an internal error.
One of the protocols is trying to
add an existing TagID to the
buffer.
Send a test case reproducing the
behavior to
rfid-
[e-mail].
FAULT_TAG_ID_BUFFER_NUM_TAG_TOO
_LARGE
603h The module received a request to
retrieve more tags than is
supported by the current version
of the software.
Send a test case reproducing the
behavior to rfid-
[e-mail].
System Fault Errors
Message Code Cause Solution
FAULT_SYSTEM_UNKNOWN_ERROR 7F00h The error is internal. Send a test case reproducing the
behavior to rfid-
[e-mail].
FAULT_TM_ASSERT_FAILED 7F01h An unexpected internal error has
occurred.
The error will cause the module to
switch back to Bootloader mode.
When this occurs make note of the
operations you were executing, save
FULL error response and send a test
case reproducing the behavior to rfid-
[e-mail].