User Manual

ThingMagic Nano User Guide 47
www.JADAKtech.com
EU Compliance
European Union Declaration of Conformity for
M6E-NANO RFID Reader Module
The object described above conforms to the requirements of EU directives through full compliance with the following standards:
European Standards
The notified body Curtis-Straus LLC, NB1797 performed review of test reports on the object of this declaration and issued the EU-type examination certificate
CS22408.
It is required that antenna gain must +8 dBiL or less to allow the object to operate as intended, and to be covered by this declaration of conformity.
Document No. 875-0218-01 Rev A
Novanta Corporation
125 Middlesex Turnpike Bedford, MA 01730-1409 Tel: [phone] Fax: [phone] www.novanta.com
EU Authorized Antennas
EU regulations requires that the radiated output of this device not exceed +33 dBm ERP. ERP power is
calculated by taking the output level of the Nano (+27 dBm maximum), subtracting any cable losses
between the Nano and the antenna, and adding the antenna gain in dBd units. “dBd” refers to the gain of
the antenna with respect to that of a linear dipole antenna. A dipole has gain of 2.15 dBiL, so if the antenna
Manufacturer: Novanta Corporation
Address: 125, Middlesex Turnpike
Bedford, MA 01730
Object of the declaration:
Product Model Numbers:
M6E-M, M6E-MICRO
Object description:
Product Description:
865-869 MHz and 902 to 928 MHz Radio Frequency Identification (RFID) Reader /
Interrogator Module.
This declaration of conformity is issued under the sole responsibility of the manufacturer.
The object of the declaration described above is in conformity with the following relevant European Union harmonization
Legislation:
Directives:
Identifier Date
2014/53/EU 16 April 2014
2011/65/EU w/ Amendments M1-M30 19 April 2016
Standard Amendments
ETSI EN 302 208 V3.1.1 (2016-11) None
ETSI EN 301 489-3 V2.1.0 (2016-09) Draft
CENELEC EN 50581:2012 None
Authorized on Behalf of Novanta Corporation:
Name Eva Gravius
Function VP Engineering
Address North Syracuse, New York
Date May 8, 2017
Signature