User Manual

ThingMagic Nano User Guide 26
www.JADAKtech.com
Carrier Board Heat Sinking
ThingMagic Nano can run at full RF power at room temperature on stand-offs in the Development Kit. If you
wish to test the ThingMagic Nano under extreme temperature conditions, you may want to mount it on the
heat spreader that is supplied with the Micro modules for the xPRESS Sensor Hub. Make sure it is
assembled as shown in these pictures, so no live signals are shorted to ground.
Mount Nano on Heat Spreader Assembly
NOTE: Xpress Sensor Hub firmware does not support the ThingMagic Nano module currently.